| Strap
hinges - $75 ea
Available in 18" 24" or
30 " lengths
All 1/4 X 1 1/4 stock
|
 |
| Hinge
finials - left to right:
round, spade, spike or bean
|
 |
|
| Each strap hinge will
require a pintle to make a complete hinge. Please specify
the style of pintle as well as which side of the door (left or
right) the hinges will be mounted on. Ordering is at the bottom of
this list of pintle options. |
|
Close-up
of the rat tail hinge pintle. This pintle features a lag
screw thread on the main body. The tail extends from the pin to
help prevent rotation.
A screw -n pintle is the same,
only without the rat tail.
A drive pintle uses a spike
instead of a screw for use in heavy timber.
|
 |
|
Pintle style
"A" for mounting inside the jamb. This type of pintle
uses flat head screws and does not show. Left or right hand
specific.
|
 |
|
Pintle style
"B" surface mounts for doors that lie in the same
plane as the mounting surface. This is exposed during use
so we recommend our forged head lag screws shown below.
Left or right hand specific.
|
 |
|
Pintle style
"C" surface mounts for doors that lie in the same
plane as the mounting surface. This is exposed during use
so we recommend our forged head lag screws shown below.
|
 |
|
Pintle style
"C" from the top. Notice that this type of pintle
requires an offset in your hinge strap. Not left or right hand specific.
|
 |
| Forged head lag screw for mounting
hinges or other hardware. 1/4" x 2" is the most
common size.
Screw prices start at 50 cents each.
See our page on fasteners
for more information
|
 |
|
|
|
|
